Centrifugal Spray Drying Machine-Spray Dryer-Anvore Scientific-Lab & Industrial Process Equipment

Centrifugal Spray Drying Machine

Process sequence Filtered air is heated and enters the chamber. The atomizer disperses the aqueous feed into fine droplets, moisture evaporates.

ModelAV-ASD10L

BrandANVORE

Higher-capacity aqueous pilot spray drying with 1,200 mm chamber and up to 10,000 mL/h stated feed rate

Built for controlled aqueous spray drying AV-ASD10L extends the aqueous pilot range to a stated feed rate of 10,000 mL/h. The system combines a 1,200 mm drying chamber, 480 m³/h stated inlet airflow and a water-cooled centrifugal atomizer adjustable to 25,000 rpm. Automated touch-screen control, filtered inlet air and 304 stainless-steel construction support scale-up and pilot production trials. Recommended use Best for larger pilot campaigns and pre-production scale-up of food, biological, pharmaceutical and specialty chemical powders. Process note Final feed compatibility and operating conditions should be confirmed by a process assessment.

AV-ASD10L configuration

Six Key Advantages

PRINCIPLE AND TECHNICAL DATA

Process sequence Filtered air is heated and enters the chamber. The atomizer disperses the aqueous feed into fine droplets, moisture evaporates rapidly, and the dried powder is separated and collected. Exhaust air leaves after the recovery stage.

Ambient air	→	Inlet air filter	→	Electric heater	→	Drying chamber	→	Powder and gas separation
						↑		↓
Feed solution	→	Peristaltic pump	→	Two-fluid orcentrifugal atomizer	→	Fine droplets	→	Product collectionand exhaust

Technical Specifications

Specifications are based on the supplied source document and may change with configuration. Confirm utilities, materials of construction, feed compatibility and compliance requirements before ordering.

Parameter	Specification
Model	AV-ASD10L
Feed rate	50–10,000 mL/h
Feed method	Adjustable peristaltic pump
Inlet temperature	Ambient to 250°C; electric heating
Atomization	Centrifugal
Centrifugal speed	0–25,000 rpm; adjustable
Spray-head cooling	Water cooled
Drying chamber diameter	1,200 mm
Inlet airflow	480 m³/h
Control	7-inch color touch screen
Heating power	24 kW
Observation window	Included
Electrical protection	Leakage, voltage stabilization and thermal insulation protection
Inlet dust filtration	Included
Total power	36 kW
Material	304 stainless steel
Overall dimensions	1,800 × 1,800 × 2,400 mm(LWH)

APPLICATIONS

Suitable applications depend on feed chemistry, solids content, required powder characteristics and site operating controls.

Food and Beverage Powders Coffee, flavors, drink bases and other water-based formulations.	Dairy and Proteins Milk, whey, protein and nutrition formulation development.
Pharmaceuticals and Biologics Aqueous formulation, excipient and biological material research.	Plant Extracts and Enzymes Botanical extracts, enzymes and heat-sensitive ingredients.
Pigments and Fine Chemicals Water-based dispersions, colorants and specialty chemicals.	Ceramics and Advanced Materials Functional powders, ceramics and material-development slurries.